Big Ring Gag Control Plate Corkscrew 135 B16

( 0 )


The Big Ring Gag is stronger than the usual Loose Ring and Eggbutt as the ropes going through the rings create leverage which will exert more pressure through the mouthpiece whilst at the same time introducing more poll pressure.

The Big Ring Gag is supplied with our innovative quick change polo gag ropes and bit rubbers.

The Bombers Control Plate is set at 45° to follow the contour of the horses tongue. Consequently, a horse who uses his tongue as a means of pushing against the bit and therefore taking control, will draw back and tuck his chin in, coming back to a better point of control.

material-soft-metalmaterial-oxidisation

The Corkscrew mouthpiece is grooved to offer extra control over strong horses. The groove in the mouthpiece causes edges that result in pressure points in the horse's mouth. The edges amplify pressure on the mouth, especially the bars and tongue, and also act on the lips. This offers the rider more control than a smooth mouthpiece, and can help to prevent the horse from leaning.

Big Ring Gag Control Plate Corkscrew 135 B16
Breed Mouth Width 1 4
Bit Adjustment 2 Bit Width 3 4
Arab 115 mm (4½") 5 mm + 10 mm  130 mm (5⅛")
Austrailian Stock Horse 120 mm (4¾")  135 mm (5¼")
American Quarter Horse 120 mm (4¾")  135 mm (5¼")
Thoroughbred (15h-15.3h) 120 mm (4¾")  135 mm (5¼")
Thoroughbred (16h+) 125 mm (5")  140 mm (5½")
Warmblood 125 mm (5")  140 mm (5½")
Large Warmblood 130 mm (5⅛")  145 mm (5¾")
Other MMS  MMS + 15 mm
Notes:
1 The measured width of a horse's mouth (from corner to corner with no wrinkles) rounded up to the nearest 5mm. These are typical values for the breed. MMS = Measured Mouth Size. Click here for more information on measuring your horse's mouth
2 Factors to be added to the measured width of a horse's mouth to ensure the bit width is calculated correctly. This varies depending on the mouthpiece and cheekpiece of the bit. For this bit add 5 mm for a loose ring cheek piece, to allow for space between the ring and the horse's lip, eliminating a possible pressure point and pinching. Add 10 mm for a single or double break bit. This is to allow the bit to follow the contour of the horse's mouth.
3 The width of the bit for a optimal fit, taking into account its components and the width of the horse's mouth. If calculating a bit width based upon a previously purchased Bomber bit, please make sure all relevant adjustments for differences in cheek and mouth pieces are adhered too.
4 Measurements in inches are approximate.

List of the comments:
No comments have been posted yet.