Watson Ring Pelham 125

( 0 )


The Watson Ring Pelham is like a regular Pelham , but the snaffle rings have been moved so that they are connected through the center of the Mullen mouthpiece and now act as loose rings. The bit gives the impression of being part of a double bridle setup without using two bits.

Mullen mouthpiece with a leverage cheek: This combination gives very definite downward tongue pressure. As the cheek turns, the mouthpiece of the bit pushes it down into the lower jaw. This is good for a horse with ample lower jaw capacity that needs to be ridden in something stronger than a snaffle and dislikes, or does not need, a joint or a port.

The Pelham was developed as a combination between the snaffle and curb bit. It consists of a mouthpiece, shanks with two rings per side, a curb chain and to be used correctly, two reins.

Watson Ring Pelham 125
Breed Mouth Width 1 4
Bit Adjustment 2 Bit Width 3 4
Arab 115 mm (4½") 0 mm + 0 mm  115 mm (4½")
Austrailian Stock Horse 120 mm (4¾")  120 mm (4¾")
American Quarter Horse 120 mm (4¾")  120 mm (4¾")
Thoroughbred (15h-15.3h) 120 mm (4¾")  120 mm (4¾")
Thoroughbred (16h+) 125 mm (5")  125 mm (5")
Warmblood 125 mm (5")  125 mm (5")
Large Warmblood 130 mm (5⅛")  130 mm (5⅛")
Other MMS  MMS + 0 mm
Notes:
1 The measured width of a horse's mouth (from corner to corner with no wrinkles) rounded up to the nearest 5mm. These are typical values for the breed. MMS = Measured Mouth Size. Click here for more information on measuring your horse's mouth
2 Factors to be added to the measured width of a horse's mouth to ensure the bit width is calculated correctly. This varies depending on the mouthpiece and cheekpiece of the bit. Fixed cheek pieces do not require any additional width to be added to the measured width of the horse's mouth. A fixed mouth piece does not require any additional width to be added to the measured width of the horse's mouth.
3 The width of the bit for a optimal fit, taking into account its components and the width of the horse's mouth. If calculating a bit width based upon a previously purchased Bomber bit, please make sure all relevant adjustments for differences in cheek and mouth pieces are adhered too.
4 Measurements in inches are approximate.

List of the comments:
No comments have been posted yet.