Loose Ring Cherry Roller French Link

( 0 )

Width
Thickness

The Loose Ring allows for immediate release and relief from tongue and bar pressure. The bit is immediately reset to a neutral position in the horse's mouth.

The French Link is useful for horses that dislike the 'nutcracker' effect. The French Link figure 8 shaped lozenge rests vertically on the horse's tongue applying harsh pressure but reduces the direct pressure on the outside of the bars of the mouth.

This bit is stronger than the Control Plate and the Elliptical.

material-soft-metalmaterial-oxidisation

The Cherry Rollers roll in the horses mouth giving him something to play with and reducing the likelihood of the bit being held in the horse's teeth. They are constructed tightly so there is no chance of pinching. When pulling on the reins, the rollers allow the bit to move along the bars of the horse's jaws as opposed to rubbing.

Very useful for horses that:

  • Lose sensitivity over time
  • Lose concentration
  • Cross their jaws

Loose Ring Cherry Roller French Link
Breed Mouth Width 1 4
Bit Adjustment 2 Bit Width 3 4
Arab 115 mm (4½") 5 mm + 10 mm  130 mm (5⅛")
Austrailian Stock Horse 120 mm (4¾")  135 mm (5¼")
American Quarter Horse 120 mm (4¾")  135 mm (5¼")
Thoroughbred (15h-15.3h) 120 mm (4¾")  135 mm (5¼")
Thoroughbred (16h+) 125 mm (5")  140 mm (5½")
Warmblood 125 mm (5")  140 mm (5½")
Large Warmblood 130 mm (5⅛")  145 mm (5¾")
Other MMS  MMS + 15 mm
Notes:
1 The measured width of a horse's mouth (from corner to corner with no wrinkles) rounded up to the nearest 5mm. These are typical values for the breed. MMS = Measured Mouth Size. Click here for more information on measuring your horse's mouth
2 Factors to be added to the measured width of a horse's mouth to ensure the bit width is calculated correctly. This varies depending on the mouthpiece and cheekpiece of the bit. For this bit add 5 mm for a loose ring cheek piece, to allow for space between the ring and the horse's lip, eliminating a possible pressure point and pinching. Add 10 mm for a single or double break bit. This is to allow the bit to follow the contour of the horse's mouth.
3 The width of the bit for a optimal fit, taking into account its components and the width of the horse's mouth. If calculating a bit width based upon a previously purchased Bomber bit, please make sure all relevant adjustments for differences in cheek and mouth pieces are adhered too.
4 Measurements in inches are approximate.

List of the comments:
No comments have been posted yet.