Pelham 55 Barrel 30

( 0 )

Width
Thickness

The Pelham 55 has attachments for two reins, one near the mouthpiece and one at the end of the shank. These reins have similar action to the curb and bridoon reins in the double bridle.

Some riders, not adept at handling two sets of reins, prefer to use rein connectors, leather loops which connect from one ring to the other on the bit shank. The rein is then attached to this rounding.

The Pelham 55 has the shortest shank (55 mm) out of our range, this will soften poll pressure and leverage on the mouthpiece and curb.

It is supplied with curb chain and hooks.

A conventional Snaffle joint has a nut cracker action, which means it will bear pressure on the horse's bars and the tongue. The Barrel joint limits the nut cracker action and spreads the usual pressure over a larger area. When the rein is used this mouthpiece wraps across the tongue creating tongue pressure and taking pressure off the bars due to the lock up action. Please note appearances may be deceiving, this bit joint is stronger than the Elliptical as pressure is more concentrated on the tongue as this joint is smaller.

material-oxidisation

Pelham 55 Barrel 30
Breed Mouth Width 1 4
Bit Adjustment 2 Bit Width 3 4
Arab 115 mm (4½") 0 mm + 5 mm  120 mm (4¾")
Austrailian Stock Horse 120 mm (4¾")  125 mm (5")
American Quarter Horse 120 mm (4¾")  125 mm (5")
Thoroughbred (15h-15.3h) 120 mm (4¾")  125 mm (5")
Thoroughbred (16h+) 125 mm (5")  130 mm (5⅛")
Warmblood 125 mm (5")  130 mm (5⅛")
Large Warmblood 130 mm (5⅛")  135 mm (5¼")
Other MMS  MMS + 5 mm
Notes:
1 The measured width of a horse's mouth (from corner to corner with no wrinkles) rounded up to the nearest 5mm. These are typical values for the breed. MMS = Measured Mouth Size. Click here for more information on measuring your horse's mouth
2 Factors to be added to the measured width of a horse's mouth to ensure the bit width is calculated correctly. This varies depending on the mouthpiece and cheekpiece of the bit. Fixed cheek pieces do not require any additional width to be added to the measured width of the horse's mouth. For Barrel or Lock Up mouthpieces only add 5 mm as these mechanisms limit the nut cracker action.
3 The width of the bit for a optimal fit, taking into account its components and the width of the horse's mouth. If calculating a bit width based upon a previously purchased Bomber bit, please make sure all relevant adjustments for differences in cheek and mouth pieces are adhered too.
4 Measurements in inches are approximate.

List of the comments:
No comments have been posted yet.