Pony Fulmer Happy Tongue

( 0 )

Width
Thickness

The Fulmer cheekpiece, will have the same effect as the traditional Eggbutt in so much as, it will prevent pinching on the sides of the mouth, however the extended pins above and below the bit, firstly prevent the bit being pulled through the mouth and secondly have the effect of guiding the horses head which is great for schooling and training purposes.

Our pony bits feature cheekpieces that are a ¾ scale version of our standard bits.

The Happy Tongue is a solid mouth piece. It is curved and ported to give tongue relief. The Happy Tongue would be a good place to start if your horse is:

  • Shaking its head
  • Sticking its tongue out
  • Sucking its tongue back and as a result making an intermittent coughing noise
  • Trying to put its tongue over the bit
  • Going behind the bit to avoid the contact
  • Snatching the reins forward and down

The rider will know immediately if this is the correct bit, as a horse with a sensitive tongue will finally begin to work into, and accept the contact. Changing the cheekpieces would then allow the rider to adjust the level of control.

material-oxidisation

Pony Fulmer Happy Tongue
Mouth Width 1 4
Bit Adjustment 2 Bit Width 3 4
MMS 0 mm + 0 mm  MMS + 0 mm
Notes:
1 The measured width of a horse's mouth (from corner to corner with no wrinkles) rounded up to the nearest 5mm. These are typical values for the breed. MMS = Measured Mouth Size. Click here for more information on measuring your horse's mouth
2 Factors to be added to the measured width of a horse's mouth to ensure the bit width is calculated correctly. This varies depending on the mouthpiece and cheekpiece of the bit. Fixed cheek pieces do not require any additional width to be added to the measured width of the horse's mouth. A fixed mouth piece does not require any additional width to be added to the measured width of the horse's mouth.
3 The width of the bit for a optimal fit, taking into account its components and the width of the horse's mouth. If calculating a bit width based upon a previously purchased Bomber bit, please make sure all relevant adjustments for differences in cheek and mouth pieces are adhered too.
4 Measurements in inches are approximate.

List of the comments:
No comments have been posted yet.