T-Bar Gag Elliptical 130 B16

( 0 )


The T-Bar Gag was developed by Bomber for Polo, it will have the same effect as the traditionall Fulmer in that it will prevent pinching on the sides of the mouth however the shortened and extended pins above and below the bit prevent the bit firstly being pulled through the mouth and secondly has the effect of guiding the the horses head into the direction the bit is facing which is great for schooling and training purposes.

The T-Bar has a Loose Ring fitting which allows for immediate release whilst the shortened pin extensions prevent it from being hooked up.

The Big Ring Gag is stronger than the usual Loose Ring and Eggbutt as the ropes going through the rings create leverage which will exert more pressure through the mouthpiece whilst at the same time introducing more poll pressure.

The T-Bar Gag is supplied with our innovative quick change polo gag ropes.

The Elliptical is a 45 mm lozenge, it is stronger than the Control Plate due to it having a smaller surface area. Consequently, a horse using his tongue as a means of pushing against the bit and therefore taking control, will draw back and tuck his chin in, coming back to a better point of control.

material-oxidisation

T-Bar Gag Elliptical 130 B16
Breed Mouth Width 1 4
Bit Adjustment 2 Bit Width 3 4
Arab 115 mm (4½") 0 mm + 10 mm  125 mm (5")
Austrailian Stock Horse 120 mm (4¾")  130 mm (5⅛")
American Quarter Horse 120 mm (4¾")  130 mm (5⅛")
Thoroughbred (15h-15.3h) 120 mm (4¾")  130 mm (5⅛")
Thoroughbred (16h+) 125 mm (5")  135 mm (5¼")
Warmblood 125 mm (5")  135 mm (5¼")
Large Warmblood 130 mm (5⅛")  140 mm (5½")
Other MMS  MMS + 10 mm
Notes:
1 The measured width of a horse's mouth (from corner to corner with no wrinkles) rounded up to the nearest 5mm. These are typical values for the breed. MMS = Measured Mouth Size. Click here for more information on measuring your horse's mouth
2 Factors to be added to the measured width of a horse's mouth to ensure the bit width is calculated correctly. This varies depending on the mouthpiece and cheekpiece of the bit. Fixed cheek pieces do not require any additional width to be added to the measured width of the horse's mouth. Add 10 mm for a single or double break bit. This is to allow the bit to follow the contour of the horse's mouth.
3 The width of the bit for a optimal fit, taking into account its components and the width of the horse's mouth. If calculating a bit width based upon a previously purchased Bomber bit, please make sure all relevant adjustments for differences in cheek and mouth pieces are adhered too.
4 Measurements in inches are approximate.

List of the comments:
No comments have been posted yet.